Product Name:	Human CCNB1 / Cyclin B1 ELISA Kit
Product Code:	HUFI02298
Size:	96 Assays
Alias:	CCNB, CCNB1, cyclin B1, G2, mitotic-specific cyclin B1, G2, mitotic-specific cyclin-B1
Detection method:	Sandwich ELISA, Double Antibody
Application:	This immunoassay kit allows for the in vitro quantitative determination of Human CCNB concentrations in serum plasma and other biological fluids.
Sensitivity:	0.188ng/ml
Range:	0.313-20ng/ml
Storage:	4°C for 6 months
Note:	For Research Use Only

Recovery:

Matrices listed below were spiked with certain level of Human CCNB and the recovery rates were calculated by comparing the measured value to the expected amount of Human CCNB in samples.

Matrix	Recovery range(%)	Average(%)
serum(n=5)	90-105	99
EDTA plasma(n=5)	90-100	96
UFH plasma(n=5)	88-105	99

Linearity:

The linearity of the kit was assayed by testing samples spiked with appropriate concentration of Human CCNB and their serial dilutions. The results were demonstrated by the percentage of calculated concentration to the expected.

Sample	1:2	1:4	1:8
serum(n=5)	87-105%	87-100%	87-104%
EDTA plasma(n=5)	82-91%	85-101%	86-101%
UFH plasma(n=5)	80-100%	85-99%	82-96%

CV(%):

Intra-Assay: CV<8%
Inter-Assay: CV<10%

Component	Quantity	Storage
ELISA Microplate (Dismountable)	8×12 strips	4°C for 6 months
Lyophilized Standard	2	4°C/-20°C
Sample/Standard Dilution Buffer	20ml	4°C
Biotin-labeled Antibody(Concentrated)	120ul	4°C (Protect from light)
Antibody Dilution Buffer	10ml	4°C
HRP-Streptavidin Conjugate(SABC)	120ul	4°C (Protect from light)
SABC Dilution Buffer	10ml	4°C
TMB Substrate	10ml	4°C (Protect from light)
Stop Solution	10ml	4°C
Wash Buffer(25X)	30ml	4°C
Plate Sealer	5	-

Other materials and equipment required:

Microplate reader with 450 nm wavelength filter
Multichannel Pipette, Pipette, microcentrifuge tubes and disposable pipette tips
Incubator
Deionized or distilled water
Absorbent paper
Buffer resevoir

Uniprot

P14635

UniProt Protein Function:	CCNB1: a member of the highly conserved cyclin family, whose members are characterized by a dramatic periodicity in protein abundance through the cell cycle. Cyclins function as regulators of CDK kinases. Complexes with cdc2 to form the maturation-promoting factor (MPF). Two alternatively spliced isoforms have been found, a constitutively expressed form and a cell cycle-regulated form that is expressed predominantly during G2/M phase.
UniProt Protein Details:	Protein type:Cell cycle regulation; Activator Chromosomal Location of Human Ortholog: 5q12 Cellular Component: nucleoplasm; spindle pole; centrosome; membrane; cytoplasm; nucleus; cytosol Molecular Function:protein binding; patched binding; histone kinase activity; protein kinase binding Biological Process: positive regulation of ubiquitin-protein ligase activity during mitotic cell cycle; positive regulation of histone phosphorylation; regulation of cell cycle; ventricular cardiac muscle cell development; positive regulation of attachment of spindle microtubules to kinetochore; mitotic nuclear envelope disassembly; positive regulation of mRNA 3'-end processing; positive regulation of mitotic cell cycle; positive regulation of fibroblast proliferation; negative regulation of protein amino acid phosphorylation; tissue regeneration; anaphase-promoting complex-dependent proteasomal ubiquitin-dependent protein catabolic process; protein complex assembly; G2/M transition of mitotic cell cycle; positive regulation of cardiac muscle cell proliferation; response to drug; in utero embryonic development; oocyte maturation; mitotic metaphase plate congression; response to DDT; gut development; regulation of ubiquitin-protein ligase activity during mitotic cell cycle; response to mechanical stimulus; cell division; spermatogenesis; regulation of cyclin-dependent protein kinase activity; mitotic cell cycle; mitotic spindle stabilization; G1/S transition of mitotic cell cycle
NCBI Summary:	The protein encoded by this gene is a regulatory protein involved in mitosis. The gene product complexes with p34(cdc2) to form the maturation-promoting factor (MPF). Two alternative transcripts have been found, a constitutively expressed transcript and a cell cycle-regulated transcript, that is expressed predominantly during G2/M phase. The different transcripts result from the use of alternate transcription initiation sites. [provided by RefSeq, Jul 2008]
UniProt Code:	P14635
NCBI GenInfo Identifier:	116176
NCBI Gene ID:	891
NCBI Accession:	P14635.1
UniProt Secondary Accession:	P14635,Q5TZP9, A8K066,
UniProt Related Accession:	P14635
Molecular Weight:	44,102 Da
NCBI Full Name:	G2/mitotic-specific cyclin-B1
NCBI Synonym Full Names:	cyclin B1
NCBI Official Symbol:	CCNB1
NCBI Official Synonym Symbols:	CCNB
NCBI Protein Information:	G2/mitotic-specific cyclin-B1; G2/mitotic-specific cyclin B1
UniProt Protein Name:	G2/mitotic-specific cyclin-B1
UniProt Gene Name:	CCNB1
UniProt Entry Name:	CCNB1_HUMAN

*Note: Protocols are specific to each batch/lot. For the correct instructions please follow the protocol included in your kit.

Before adding to wells, equilibrate the SABC working solution and TMB substrate for at least 30 min at 37°C. When diluting samples and reagents, they must be mixed completely and evenly. It is recommended to plot a standard curve for each test.

Step	Protocol
1.	Set standard, test sample and control (zero) wells on the pre-coated plate respectively, and then, record their positions. It is recommended to measure each standard and sample in duplicate. Wash plate 2 times before adding standard, sample and control (zero) wells!
2.	Aliquot 0.1ml standard solutions into the standard wells.
3.	Add 0.1 ml of Sample / Standard dilution buffer into the control (zero) well.
4.	Add 0.1 ml of properly diluted sample ( Human serum, plasma, tissue homogenates and other biological fluids.) into test sample wells.
5.	Seal the plate with a cover and incubate at 37 °C for 90 min.
6.	Remove the cover and discard the plate content, clap the plate on the absorbent filter papers or other absorbent material. Do NOT let the wells completely dry at any time. Wash plate X2.
7.	Add 0.1 ml of Biotin- detection antibody working solution into the above wells (standard, test sample & zero wells). Add the solution at the bottom of each well without touching the side wall.
8.	Seal the plate with a cover and incubate at 37°C for 60 min.
9.	Remove the cover, and wash plate 3 times with Wash buffer. Let wash buffer rest in wells for 1 min between each wash.
10.	Add 0.1 ml of SABC working solution into each well, cover the plate and incubate at 37°C for 30 min.
11.	Remove the cover and wash plate 5 times with Wash buffer, and each time let the wash buffer stay in the wells for 1-2 min.
12.	Add 90 µl of TMB substrate into each well, cover the plate and incubate at 37°C in dark within 10-20 min. (Note: This incubation time is for reference use only, the optimal time should be determined by end user.) And the shades of blue can be seen in the first 3-4 wells (with most concentrated standard solutions), the other wells show no obvious color.
13.	Add 50 µl of Stop solution into each well and mix thoroughly. The color changes into yellow immediately.
14.	Read the O.D. absorbance at 450 nm in a microplate reader immediately after adding the stop solution.

When carrying out an ELISA assay it is important to prepare your samples in order to achieve the best possible results. Below we have a list of procedures for the preparation of samples for different sample types.

Sample Type	Protocol
Serum	If using serum separator tubes, allow samples to clot for 30 minutes at room temperature. Centrifuge for 10 minutes at 1,000x g. Collect the serum fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. If serum separator tubes are not being used, allow samples to clot overnight at 2-8°C. Centrifuge for 10 minutes at 1,000x g. Remove serum and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles.
Plasma	Collect plasma using EDTA or heparin as an anticoagulant. Centrifuge samples at 4°C for 15 mins at 1000 × g within 30 mins of collection. Collect the plasma fraction and assay promptly or aliquot and store the samples at -80°C. Avoid multiple freeze-thaw cycles. Note: Over haemolysed samples are not suitable for use with this kit.
Urine & Cerebrospinal Fluid	Collect the urine (mid-stream) in a sterile container, centrifuge for 20 mins at 2000-3000 rpm. Remove supernatant and assay immediately. If any precipitation is detected, repeat the centrifugation step. A similar protocol can be used for cerebrospinal fluid.
Cell culture supernatant	Collect the cell culture media by pipette, followed by centrifugation at 4°C for 20 mins at 1500 rpm. Collect the clear supernatant and assay immediately.
Cell lysates	Solubilize cells in lysis buffer and allow to sit on ice for 30 minutes. Centrifuge tubes at 14,000 x g for 5 minutes to remove insoluble material. Aliquot the supernatant into a new tube and discard the remaining whole cell extract. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
Tissue homogenates	The preparation of tissue homogenates will vary depending upon tissue type. Rinse tissue with 1X PBS to remove excess blood & homogenize in 20ml of 1X PBS (including protease inhibitors) and store overnight at ≤ -20°C. Two freeze-thaw cycles are required to break the cell membranes. To further disrupt the cell membranes you can sonicate the samples. Centrifuge homogenates for 5 mins at 5000xg. Remove the supernatant and assay immediately or aliquot and store at -20°C or -80°C.
Tissue lysates	Rinse tissue with PBS, cut into 1-2 mm pieces, and homogenize with a tissue homogenizer in PBS. Add an equal volume of RIPA buffer containing protease inhibitors and lyse tissues at room temperature for 30 minutes with gentle agitation. Centrifuge to remove debris. Quantify total protein concentration using a total protein assay. Assay immediately or aliquot and store at ≤ -20 °C.
Breast Milk	Collect milk samples and centrifuge at 10,000 x g for 60 min at 4°C. Aliquot the supernatant and assay. For long term use, store samples at -80°C. Minimize freeze/thaw cycles.

Fill out our quote form below and a dedicated member of staff will get back to you within one working day!

इंटरल्यूकिन-8 सिग्नलिंग

ग्लाइकोलाइसिस मार्ग विस्तार से: ग्लूकोज को ऊर्जा में कैसे बदला जाता है

आरएनएआई क्या है? तुम्हें सिर्फ ज्ञान की आवश्यकता है

Human CCNB1 / Cyclin B1 ELISA Kit

Description